Description
This article provides step-by-step instructions for setting up and operating the HOVERAir X1 self-flying camera. The steps below cover downloading the companion app, charging the battery, powering on the device, selecting a flight mode, landing, and connecting to the app to manage your recorded content.
Procedure
Step 1: Download the App
Scan the QR code below to download and install the Hover X1 app.
Step 2: Charge the Battery
Before using HOVERAir X1 for the first time, be sure to charge the battery fully.
Video tutorial on charging your battery here:
Step 3: Power On
Press and hold the power button for 2 seconds until you hear the voice prompt and the green status indicator turns on.
Note: Do NOT insert any finger or object into the propeller area. To stop HOVERAir X1 mid-flight, grab it from the air and press the power button, or flip it 180° to stop the propellers. For full safety information, refer to the safety instruction manual and disclaimer at zzrobotics.com/support.
Step 4: Select a Mode and Fly
- Open the HOVERAir X1 enclosure as shown below.
- Switch modes using the mode button.
- Hold HOVERAir X1 horizontally.
- Short press the power button. All propellers will start spinning.
- Release HOVERAir X1. It will take off and perform the selected flight path.
Take off
Step 5: Land HOVERAir X1
When HOVERAir X1 has finished its flight path, place your hand 20 cm below it. It will automatically land on your hand.
Step 6: Connect to the App
Open the Hover X1 app to download your content or adjust flight parameters.
